FCP适配器初始化失败—AutoSupport 消息

最后更新
另存为PDF

Knowledge Base guidance

This article may include metadata, visibility, validation state, and related support guidance.

适用场景

ONTAP 9
callhome.fcp.adapter.failed：错误

事件摘要

如果此节点中的光纤通道协议(Fibre Channel Protocol、FCP) HBA主机总线适配器(Host Bus Adapter、HBA)无法从适配器的内部配置中读取关键设置、则会出现此消息。应更换适配器。

验证

主叫事件

HA Group Notification from Node Name (FCP ADAPTER INITIALIZATION FAILED, Port: 0) ERROR

EMS日志

::>event log show -severity * -message-name callhome*

Fri Jan 29 14:13:46 +0100 [Node Name: sysinit_thread: callhome.fcp.adapter.failed:error]: Call home for FCP ADAPTER INITIALIZATION FAILED, Port: 0

命令行

::>system node run -node <node name> -command sysconfig

slot 0: Fibre Channel Target Host Adapter 0d (QLogic CNA 8324 (8362) rev. 2, <LINK NOT CONNECTED>) Firmware rev: 8.9.0 Flash rev: 7.0.3 Host Port Addr: 000000 FC Nodename: 50:0a:xx:xx:xx:xx:xx:xx (500axxxxxxxxxxxx) FC Portname: 50:0a:xx:xx:xx:xx:xx:xx (500axxxxxxxxxxxx) Connection: No link Switch Port: Unknown SFP Vendor Name: AVAGO SFP Vendor P/N: AFBR-709SMZ-NA1 SFP Vendor Rev: G4.1 SFP Serial No.: XXXXXXXXXX SFP Connector: LC SFP Capabilities: 10 Gbit/Sec

解决方法

请联系NetApp技术支持并参考此文章以获得进一步帮助。解决方案可能需要更换部件。

追加信息

在此处添加您的文本。