跳转到主内容

BES-53248交换机信息未显示在device-discovery下

i
Knowledge Base guidance

This article may include metadata, visibility, validation state, and related support guidance.

适用场景

  • 采用EFOS 3.7.0.4及更高版本的BES-53248网络交换机
  • ONTAP 9
  • MetroCluster IP ( MCCIP )

问题描述

  • 在两个BES-53248交换机上将EFOS升级到3.7.0.4后、MCCIP中的一个控制器将不再显示中的集群网络交换机 device-discovery show
  • 交换机日志可确认存储端端口已正确显示在下 show isdp neighbors
    *************** show isdp neighbors *************** Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge, S - Switch, H - Host, I - IGMP, r - Repeater Device ID Intf Holdtime Capability Platform Port ID ------------------------ --------- --------- ---------- ---------------- --------- Node-01 0/9 150 H AFF-A220 e0b Node-02 0/10 149 H AFF-A220 e0b Switch-01 0/55 177 R S BES-53248 0/55 Switch-01 0/56 177 R S BES-53248 0/56
  • 下会观察到校验和错误不断增加 cdpd show-stats
    Cluster::*> run -node Node-01 cdpd show-stats
    RECEIVE Packets: 611k | Csum Errors: 366k | Unsupported Vers: 0 Invalid length: 0 | Malformed: 0 | Mem alloc fails: 0 Missing TLVs: 0 | Cache overflow: 0 | Received Own Adv: 0 Other errors: 0 | Unknown TLV: 0 | Ejected entries: 0 Eject failed: 0 | Bad Value: 0 TRANSMIT Packets: 76375 | Xmit fails: 0 | No hostname: 0 Packet truncated: 0 | Truncate fails: 0 | Mem alloc fails: 0 Other errors: 0
  • 受影响的控制器间歇性报告交换机的警告、例如以下警告
    Thu Aug 25 13:29:06 +0200 [Node-01: client_common_RPC: csm.mismatchRemoteDevice:error]: CSM connection between source LIF 1023 and destination address xxx.xxx.xxx.xxx might not be optimal for session xxxxxxxxxxxxxxxx. The source is currently connected to - remote device and the destination is currently connected to Switch-01 remote device. Thu Aug 25 13:29:06 +0200 [Node-01: client_common_RPC: csm.mismatchRemoteDevice:error]: CSM connection between source LIF 1024 and destination address xxx.xxx.xxx.xxx might not be optimal for session xxxxxxxxxxxxxxxx. The source is currently connected to - remote device and the destination is currently connected to Switch-02 remote device. Thu Aug 25 13:29:06 +0200 [Node-01: client_common_RPC: csm.mismatchRemoteDevice:error]: CSM connection between source LIF 1023 and destination address xxx.xxx.xxx.xxx might not be optimal for session xxxxxxxxxxxxxxxx. The source is currently connected to - remote device and the destination is currently connected to Switch-01 remote device. Thu Aug 25 13:29:06 +0200 [Node-01: client_common_RPC: csm.mismatchRemoteDevice:error]: CSM connection between source LIF 1024 and destination address xxx.xxx.xxx.xxx might not be optimal for session xxxxxxxxxxxxxxxx. The source is currently connected to - remote device and the destination is currently connected to Switch-02 remote device. Thu Aug 25 13:29:06 +0200 [Node-01: client_common_RPC: csm.mismatchRemoteDevice:error]: CSM connection between source LIF 1023 and destination address xxx.xxx.xxx.xxx might not be optimal for session xxxxxxxxxxxxxxxx. The source is currently connected to - remote device and the destination is currently connected to Switch-01 remote device. Thu Aug 25 13:29:06 +0200 [Node-01: client_common_RPC: csm.mismatchRemoteDevice:error]: CSM connection between source LIF 1024 and destination address xxx.xxx.xxx.xxx might not be optimal for session xxxxxxxxxxxxxxxx. The source is currently connected to - remote device and the destination is currently connected to Switch-02 remote device.
  • 从交换机收集的数据包跟踪可确认Cisco发现协议(CDP)数据包已正确转发到存储
  • 在节点之间迁移集群LIF、然后禁用并重新启用端口、这一点毫无区别
  • 在节点之间执行接管和交还并不起作用
  • 将ONTAP 更新到9.9.1P10或9.10P6版不会导致任何更改
  • 对存储和交换机进行物理检查可确认所有端口和缆线均正常工作